​
Prerequisites

You will need
  • talosctl
  • an SD card
Download the latest talosctl.

​
Download the Image using Image Factory

The default schematic id for “vanilla” Orange Pi R1 Plus LTS is da388062cd9318efdc7391982a77ebb2a97ed4fbda68f221354c17839a750509. Refer to the Image Factory documentation for more information. Download the image and decompress it:

​
Writing the Image

The path to your SD card can be found using fdisk on Linux or diskutil on macOS. In this example, we will assume /dev/mmcblk0. Now dd the image to your SD card: 
sudo dd if=metal-arm64.raw of=/dev/mmcblk0 conv=fsync bs=4M

​
Bootstrapping the Node

Insert the SD card to your board, turn it on and wait for the console to show you the instructions for bootstrapping the node. Following the instructions in the console output to connect to the interactive installer: 
talosctl apply-config --insecure --mode=interactive --nodes <node IP or DNS name>
Once the interactive installation is applied, the cluster will form and you can then use kubectl.

​
Retrieve the kubeconfig

Retrieve the admin kubeconfig by running: 
talosctl kubeconfig

​
Upgrading

For example, to upgrade to the latest version of Talos, you can run: